Spin Stencil Disk Maker

Turn an SVG drawing into a disk of scattered slots. Pin the disk to paper through its centre, line each rim number up with one mark, trace the matching slots, and after a full turn the drawing appears. Everything runs in your browser; your file is not uploaded.

1. Drawing

Choose an SVG file or drop one here

No file handy?

2. Disk

blank = auto
More options

Starting up…

How to use the disk

  1. In the cut file, red lines are cuts and blue lines are pen (numbers and rim ticks). Check the disk measures the diameter you asked for after importing it into your cutter software.
  2. Push a pin through the centre hole into the paper.
  3. Make one mark on the paper next to the START tick.
  4. Turn the disk so rim number 1 is at your mark and trace every slot labelled 1. Repeat for 2, 3, and so on.
  5. Lift the disk.